An experimental study of a plane turbulent wall jet using particle image velocimetry
Date
2010-08
Authors
Journal Title
Journal ISSN
Volume Title
Publisher
ORCID
Type
Degree Level
Masters
Abstract
This thesis documents the design and fabrication of an experimental facility that was built to produce a turbulent plane wall jet. The target flow was two-dimensional with a uniform profile of the mean streamwise velocity and a low turbulence level at the slot exit. The design requirements for a flow conditioning apparatus that could produce this flow were determined. The apparatus was then designed and constructed, and measurements of the fluid flow were obtained using particle image velocimetry (PIV). The first series of measurements was along the slot width, the second series was along the slot centerline and the third was at 46 slot heights off the centerline. The Reynolds number, based on the slot height and jet exit velocity, of the wall jet varied from 7594 to 8121. Data for the streamwise and transverse components of velocity and the three associated Reynolds stress components were analyzed and used to determine the characteristics of the wall jet.
This experimental facility was able to produce a profile of the mean streamwise velocity near the slot exit that was uniform over 71% of the slot height with a streamwise turbulence that was equal to 1.45% of the mean velocity. This initial velocity was maintained to 6 slot heights. The fully developed region for the centerline and the off-centerline measurements was determined to extend from 50 to 100 slot heights and 40 to 100 slot heights, respectively. This was based on self-similarity of the mean streamwise velocity profiles when scaled using the maximum streamwise velocity and the jet half-width. The off-centerline Reynolds stress profiles achieved a greater degree of collapse than did the centerline profiles.
The rate of spread of the wall jet along the centerline was 0.080 in the self-similar region from 50 to 100 slot heights, and the off-centerline growth rate was 0.077 in the self-similar region from 40 to 100 slot heights. The decay rate of the maximum streamwise velocity was -0.624 within the centerline self-similar region, and -0.562 within the off-centerline self-similar region. These results for the spread and decay of the wall jet compared well with recent similar studies.
The two-dimensionality was initially assessed by measuring the mean streamwise velocity at 1 slot height along the entire slot width. The two-dimensionality of this wall jet was further analyzed by comparing the centerline and off-centerline profiles of the mean streamwise velocity at 2/3, 4, 50, 80, and 100 slot heights, and by comparing the growth rates and decay rates. Although this facility was able to produce a wall jet that was initially two-dimensional, the two-dimensionality was compromised downstream of the slot, most likely due to the presence of return flow and spanwise spreading. Without further measurements, it is not yet clear exactly how the lack of complete two-dimensionality affects the flow characteristics noted above.
Description
Keywords
flow conditioning, two-dimensional flow, return flow, self-similarity, spread rate, decay rate
Citation
Degree
Master of Science (M.Sc.)
Department
Mechanical Engineering
Program
Mechanical Engineering