Chemistry
Permanent URI for this collection
Browse
Browsing Chemistry by Subject "chitosan"
Now showing 1 - 2 of 2
Results Per Page
Sort Options
Item A Fixed-Bed Column with an Agro-Waste Biomass Composite for Controlled Separation of Sulfate from Aqueous Media(MDPI, 2023) Solgi, Mostafa; Steiger, Bernd; Wilson, LeeAn agro-waste composite with a pelletized form was prepared and characterized via IR and 13C solids NMR spectroscopy. Thermal gravimetry analysis (TGA) was used to study the weight loss profiles, while SEM images provided insight on the biocomposite morphology, along with characterization of the sulfate adsorption properties under equilibrium and dynamic conditions. The sulfate monolayer adsorption capacity (qe = 23 mg/g) of the prepared agro-waste pellets was estimated from the adsorption isotherm results by employing the Langmuir model, and comparable fitting results were obtained by the Freundlich model. The dynamic adsorption properties were investigated via adsorption studies with a fixed bed column at pH 5.2. The effects of various parameters, including flow rate, bed height and initial concentrations of sulfate, were evaluated to estimate the optimal conditions for the separation of sulfate. The experimental data of the breakthrough curves were analyzed using the Thomas and Yoon–Nelson models, which provided satisfactory best-fits for the fixed bed kinetic adsorption results. The predicted adsorption capacities for all samples according to the Thomas model concur with the experimental values. The optimum conditions reported herein afford the highest dynamic adsorption capacity (30 mg/g) as follows: 1100 mg/L initial sulfate concentration, 30 cm bed height and 5 mL/min flow rate. The breakthrough time was measured to be 550 min. This study contributes to a strategy for controlled separation of sulfate using a sustainable biocomposite material that is suitable for fixed-bed column point-of-use water treatment systems.Item Moisture Content and Mechanical Properties of Bio-Waste Pellets for Fuel and/or Water Remediation Applications(MDPI, 2023) Anisimov, Yuriy A.; Steiger, Bernd; Cree, Duncan; Wilson, LeeThe current research is focused on the mutual comparison (mechanical properties, response to humidity) of agro-waste composite materials. The purpose of this work is directed at the valorization of agro-waste biomass products and to investigate their mechanical stability for transport or other applications (in dry and wet states). Three different types of agro-waste (oat hull (Oh), torrefied wheat straw (S), and spent coffee grounds (SCG)) were blended with kaolinite (K) and chitosan (CHT) at variable weight ratios to yield ternary composites. Mechanical properties were represented by measuring hardness (in compression mode) and elastic modulus (under tension mode). Young’s (elastic) modulus was measured both for dried and hydrated samples. The pelletized materials were prepared in two forms: crosslinked (CL) with epichlorohydrin and non-crosslinked (NCL). The hardness of the Oh pellets was poor (75 N) and decreased by four times with greater agro-waste content, while crosslinking affected the hardness only slightly. S pellets had the highest level of hardness at 40% agro-waste content (160 N), with a concomitant decrease to 120 N upon crosslinking. SCG pellets had the least change in hardness for both CL and NCL specimens (105–120 N). The trends of Young’s modulus were similar to hardness. Hydration caused the elastic modulus to decrease ca. 100-fold. In general, S and SCG composites exhibit the greatest hardness and Young’s modulus compared to Oh composites (CL or NCL) in their dry state.