Damping subsynchronous resonance oscillations using a VSC HVDC back-to-back system
Date
2006-06-07
Authors
Journal Title
Journal ISSN
Volume Title
Publisher
ORCID
Type
Degree Level
Masters
Abstract
A problem of interest in the power industry is the mitigation of severe torsional oscillations induced in turbine-generator shaft systems due to Subsynchronous Resonance (SSR). SSR occurs when a natural frequency of a series compensated transmission system coincides with the complement of one of the torsional modes of the turbine-generator shaft system. Under such circumstances, the turbine-generator shaft system oscillates at a frequency corresponding to the torsional mode frequency and unless corrective action is taken, the torsional oscillations can grow and may result in shaft damage in a few seconds. This thesis reports the use of a supplementary controller along with the Voltage Source Converter (VSC) HVDC back-to-back active power controller to damp all SSR torsional oscillations. In this context, investigations are conducted on a typical HVAC/DC system incorporating a large turbine-generator and a VSC HVDC back-to-back system. The generator speed deviation is used as the stabilizing signal for the supplementary controller. The results of the investigations conducted in this thesis show that the achieved control design is effective in damping all the shaft torsional torques over a wide range of compensation levels. The results and discussion presented in this thesis should provide valuable information to electric power utilities engaged in planning and operating series capacitor compensated transmission lines and VSC HVDC back-to-back systems.
Description
Keywords
VSC HVDC back-to-back system, Subsynchronous resonance, FACTS
Citation
Degree
Master of Science (M.Sc.)
Department
Electrical Engineering
Program
Electrical Engineering